This screw located in the battery compartment.STEP 4.Lift up the top side of the cover as it shown on the picture below.STEP 5.Be careful, there is a cable connecting this cover to the motherboard.Carefully turn the cover upside down and place it on the keyboard.STEP 6.Now you can disconnect the cable from the media control board.In order to disconnect the cable, you’ll have to unlock the connector.The locking tab opens up like a hinge at a 90 degree angle.
You should use PC2-6400 DDR 2-800 memory modules.STEP 3.Remove one screw securing the media control board cover.
Dell optiplex 210l dcne install#
It means you can install up to 2GB RAM module into each slot. It cannot be removed until you remove the top cover assembly.The guide might work for other Dell Studio 17xx models.Before you start, make sure the computer is turned off and battery removed.STEP 1.Loosen eight screws securing the bottom cover.STEP 2.Remove the bottom cover.Under the cover you’ll get access to laptop hard drive, both memory modules, wireless card, CMOS battery, heatsink.It’s not necessary to remove all these parts (except the HDD) for the purpose of my disassembly, so I’ll leave them connected.By the way, this model can take 4GB RAM max.
I’m taking it apart in order to replace failed DVD drive.Dell Studio 1735/1737 comes with a slot-load DVD drive which is mounted inside the case.
Dell optiplex 210l dcne how to#
Dell | 49 In this guide I explain how to disassemble a Dell Studio 1735/1737 laptops.
0 kommentar(er)
